Kramer Electronics user manual Defining the WP-500, WP-500Rear Panel Features, Function

Defining the WP-500

Figure 2 and Table 2 define the WP-500rear panel:

			Figure 2: WP-500 Rear Panel
		Table 2: WP-500 Rear Panel Features
#	Feature		Function
1	IR OUT		Controls the display device via an IR emitter (for example, in cases
			where RS-232 control is not available)
2	VIDEO OUT		Connect to the video IN of the display device
3	AUDIO OUT 21		Connect to the audio input associated with the Video Input channel of
			the display device
4	AUDIO OUT 11		Connect to the audio input associated with the PC graphics Input
			channel of the display device
5	+ 12V DC		Connect to power the unit
6	ETHERNET Port		Connect to the local computer network for accessing the stored Web
			pages, for remote control and management from the Kramer Site-CTRL
			software and for remote configuration file and firmware updates upload
7	Grounding Screw		Connect to grounding wire
8	RS-232 Port		Connect to the RS-232 connector on the display device
9	VGA (PC) OUTPUT		Connect to the PC graphics IN of the display device
10	Factory Reset Button2		Push3 to erase the configuration and reset to the factory default definitions4:
			IP Address:	192.168.1.39
			Mask:	255.255.0.0
			Gateway:	0.0.0.0

1 Both output ports are identical

2 This operation should be carried out by authorized Kramer technical personnel or by an external system integrator, and requires removal of the device from the wall by unscrewing the four wall mount screws

3 Using a small screwdriver

4 Disconnect the power and then connect it while pressing the Factory Reset button. The unit will power up and load its memory with the factory default definitions

4 KRAMER: SIMPLE CREATIVE TECHNOLOGY