Using Your WP-500

Figure 3: Connecting the WP-500 Front Panel

2.On the rear panel, connect the display device (for example, a projector) as follows. Connect the:

VGA (PC) OUTPUT to the PC Graphics (15-pin HD connector or RGBHV connector) input on the projector

VIDEO OUT output (VIDEO OUT, GND) to the video input on the projector

AUDIO OUT 1 and AUDIO OUT 2 outputs to the audio input of the video and PC inputs on the projector1

RS-232 port to the PC control port of the projector and/or the IR OUT to the IR receiver of the projector

3.Connect the ETHERNET port to a PC for configuration and control (not shown in Figure 4), see section 5.2.

1 You can connect either AUDIO OUT 1 or AUDIO OUT 2 to either the PC or the CV input of the projector since both audio outputs are identical

6

KRAMER: SIMPLE CREATIVE TECHNOLOGY

Page 8
Image 8
Kramer Electronics user manual Connecting the WP-500 Front Panel