Kreisen KR-370T owner manual Equipment, Connection to, VCR Setup, Cable TV Setup

equipment

VCR Setup

-In Video mode, TV automatically reverts to TV mode if the CH F / G button or number buttons are pressed.

Connection 1

Set VCR switch to 3 or 4 and then tune TV to the same channel num- ber.

Connection 2

1. Connect the audio/video output jacks on VCR to the corresponding

input jacks on the TV. When connecting the TV to a VCR, match the

jack colors (Video = yellow, Audio Left = white, and Audio Right =

red).

VIDEO L AUDIO R		VIDEO L AUDIO R		S-VIDEO ANT. IN	AC INPUT
	AV1		AV2

Typical

Antennas

External

2. Insert a video tape into the VCR and press PLAY on the VCR. (Refer

to the VCR owner’s manual.)

3. Use the INPUT SELECT button on the remote control to select AV1

or AV2. (If connected to S-VIDEO on side panel, select the S-Video

external input source.)

Direct Connection

ANT IN
ANT OUT S-VIDEO	OUT
	IN
CH3	CH4	VIDEO
	(R) AUDIO (L)

VCR

Connection to

Cable TV Setup

-After subscribing to a local cable TV service and installing a converter, you can watch cable TV programming.

-For further cable TV information, contact a local cable service provider.

Connection 1

1.Select 3 or 4 with channel switch on cable box.

2.Tune the TV channel to the same selected output channel of cable box.

3.Select channels at the cable box or with the cable box remote control.

Connection 2

1.Connect the audio/video output jacks on Cable Box to the corre- sponding input jacks on the TV. When connecting the TV to Cable Box, match the jack colors

(Video = yellow, Audio Left = white, and Audio Right = red).

2.Use the INPUT SELECT button on the remote control to select AV1 or AV2.

3.Select channels with the cable box remote control.

VIDEO L AUDIO R		VIDEO L AUDIO R		S-VIDEO ANT. IN	AC INPUT
	AV1		AV2

(R) AUDIO (L)	VIDEO
TV
VCR	RF	Cable

Cable Box

12