QUESTIONS AND ANSWERS
Q. When I turn up the volume on the
A. Hum can be caused by several different disturbances. Check to make sure all of the cables into and out of the
contact. Make sure there are no power supplies or hum inducing components on top or directly below the
You could also be experiencing a ground loop in the system. Put a 3 prong to 2 prong AC adapter (cheater plug) on the
the hum. If the hum persists, you may need to repeat this procedure on
additional components in the system. Please contact your dealer or
equipment manufacturer before lifting the ground on any component.
Remember to always keep one major component grounded. If these suggestions do not lead to a solution, please consult your dealer or KRELL.
Q. Can the
A. Yes, the
Q. When I select the B1 input on
A. More than likely there is not a problem with the
or output internal cable terminations could be incorrect. Locate the channel of the system that appears to have less gain. Switch that channel's input cables. If the problems now appears in the other channel, it is a defective cable. If the problem remains in the original channel, check the
Check to make sure there are no Balance LEDs illuminated. If there are, correct the balance by pressing the balance control buttons on the remote control until no LEDs are illuminated.
Q. WhenI use my surround processor, where should I set the volume on the
A. When using the
control is performed by the surround sound processor. This eliminates the need to predetermine a proper volume setting for the
11