Krell Industries KRC-3 manual Input And Output Connections

INPUT AND OUTPUT CONNECTIONS

CAUTIONS:When making connections to this or any other component, make sure

all components are OFF. Make sure all cable terminations are of the highest quality, free from frayed ends, shorts, or cold solder joints.

1.Connect the left and right outputs of your source components to the input on the KRC-3.

The KRC-3 is equipped with four single-ended inputs (S1, $2, S3/proc, and S4/tape) and one balanced input (B1). The S1 and $2 inputs are standard

single-ended inputs while S3/proc and S4/tape have user-configurable

options. The S3/proc and S4/tape are set as standard inputs from the

factory. The S3/proc input can be set for use as a surround processor

throughput and the S4/tape can be set as a tape monitor input. Both options will be discussed on page 6 in Optional Configurations.

2. Connect the output of the KRC-3 to the input of your power amplifier.

The KRC-3 has balanced outputs via XLR type connectors and single-ended

outputs via RCA type connectors. Both outputs are active at all times,

allowing simultaneous connection to separate amplifiers. Only one of these outputs should be connected to a single stereo amplifier.

NOTE: When connecting inputs or outputs to the KRC-3, remember that the

balanced connections will have 6dB more gain than the single-ended

connections. When level matching is critical in your installation, keep this specification in mind.

3. Plug the AC cord into the receptacle on the back of the KRC-3. Plug the

remaining end into the AC wall receptacle. The blue pilot LED will illuminate, and the KRC-3will be ready for operation.

4