CONNECTIONS -
TAPE MONITOR INPUTS AND OUTPUTS
1 Digital only tape output: Intended for
2 Digital monitor inputs using auto selection system
1 AT&Tnormally active, priority over coax input
1 coax selected by default system
The digital signal at the tape output is the active digital input
signal selected. The use of external clock or TimeSync feature does not interfere with the output of the selected digital signal to the tape output RCA.
The digital |
| TAPE MONITORinput allows either | an AT&Tinput | or | ||||
a coax | input. | The AT&Tis the | active | input if there is digital | data | |||
present | at | the AT&Treceiver. | If | no data is present at | the | AT&T | ||
receiver, | the | internal default | logic | automatically | selects | the | coax | |
input. |
|
|
|
|
|
| ~ |
|
The use of the MONITORbutton TAPEIN inputs on the rear panel.
interfere with the input selection output.
on the front panel selects the The use of this input does not being sent to the Digital tape
NOTE: The Tape input can also be used as an additional source input, without use of the digital record output. This input signal
cannot appear at the digital tape output jack.
CAUTION:The Tape output is a digital signal and can not be used as an analog output to drive front end components such as a preamplifier or cassette recorder.,
NOTE: The selected digital input is always routed to the tape
output regardless of the SOURCE/MONITORbutton position.
PAGE 14
