CONNECTIONS
The operation of the Processor utilizing the TimeSync feature requires that the data input be selected first and then the
TimeSync input be selected. The TimeSync and the DATAinput selected must be from the same source. If the DATAand TimeSync
are from different sources the processor will, after a very short
period, go into a MUTEmode. The MUTEmode can be cleared by
pressing the TimeSync button again, reselecting a DATAinput,
and then optionally selecting the TimeSync if this input is connected to the same data source.
NOTE: The use of the TimeSync feature does eliminate the jitter
normally encountered in the normal decoding of the digital data
stream; however, the proprietary Krell DATA RECOVERYAND
JITTER RF_~ECTION MODULE reduces jitter to an almost
unmeasurable level. TimeSync provides an additional level of Jitter reduction.
NOTE: The use of the TimeSync button without having an actual
TimeSync input or a mismatched input( different input selected
than the input from which the TimeSync signal originates) will
cause the processor to go into MUTEmode. The TimeSync input select LEDwill flash when the mismatch condition or no input is present. The frequency indicator LEDwill still indicate the input frequency of the selected input.
NOTE: The TimeSync system is connected with an AT&TST type fiber optic cable.
