Krown Manufacturing KBS300RX Cont, MOUNTING THE KA300TX ON THE EXISTING ALARM, KA300RX RECEIVER

CHAPTER 3 (CONT.)

MOUNTING THE KA300TX ON THE EXISTING ALARM

Use the self adhesive Velcro to attach the KA300TX to the siren of the existing alarm unit. Do not block the window of the smoke chamber or on top of the alarm sensor.

KA300TX

Self adhesive velcro

Existing Alarm Unit

KA300RX RECEIVER

The alarm monitor KX300RX is designed to learn the operation code from your trans- mitter and program it to the memory.

Important note: To protect your hearing from the loud siren when you are programming the receiver, do not set the power switch to position of strobe and siren combined. Do not remove the protection cover on the strobe and do not plug in the adapter. Exposing your eyes to the ultra-bright light from the RX at a close distance may be harmful to your vision.

KA300RX can program up to three operation codes in memory. These memories will make the KA300RX becomes an extremely flexible device to setup for a multi-family dwelling. The status of these memories will be shown on the three alarm LEDs, 10 seconds after you turn on power switch. If these memories are empty, all three LED will flash when the power is turned on. If one memory is taken, one LED will stay lit when the other will con- tinue to flash. After a code is recorded into memory, the KA300RX will extend 10 sec more to accept a new operation code sent from the other transmitters. When the start-up is finished and the LEDs are off; the receiver will not accept any new codes.

Follow these steps every time you change the operation code:

1.Make sure your KA300TX is turn on.

2.Take one of the KA300TX and set it by the KA300RX.

3.Turn on the KA300RX by sliding the power switch to strobe only position while pressing the test button on the KA300TX for 2 seconds.

4.Release the test button when one of the event LED becomes stable. The new operation code is programmed to KA300RX memory.

After the KA300RX has learned your operation code, there will be no need to repeat these steps even it you turn off the unit.

If your system does not work properly, check and make sure the system’s units are installed correctly and battery levels are adequate before inspecting the DIP switch. If you wish to change to a new code, use a small screwdriver to set the DIP switches. Repeat the learning process for all KA300RX receivers.

ERASE KA300RX MEMORY

If all three LEDs on the KA300RX are stable when you turn on the power switch, your KA300RX memory is full. To erase those memories, unplug the AC adapter cord and detach the battery from the unit for 10 seconds. Repeat the previous steps to set up a new operation code.

8