4: TEST & TROUBLESHOOTING
TROUBLESHOOTING:
If any question should arise during the installation and testing, follow through the fre- quently asked questions below. Contact CompuTTY or your authorized dealer if you should have any more questions that these FAQs do not answer.
1.I have more than three different kinds of alarm devices, how can I program it to one receiver?
The KA300RX has only three LEDs to indicate the channel triggered the alarm. For example: you have five alarm devices for fire, flame, carbon monoxide, hurri- cane, and tornado alert. You must use two receivers to have enough LEDs to indi- cate the cause of the alarm. Set the devices to two groups. One is for fire alarm purpose and the other is for weather alert. Set two different operation codes. One is for each group. Program each the receiver with transmitter in the same group fol- lows the instructions in Chapter 5. Test thoroughly to make sure it functions as desired. IMPORTANT NOTE: Install the KA300RX receivers five feet away from each other to prevent interference.
2.My bed shaker does not work.
The KBS300RX is a receiver. Check the LEDs to make sure that the AC power is good and the battery is installed. Program it following steps in Chapter 3.
If you use only one operation code for your household, you need only one transmit- ter to program the
3.There is channel LED on my KA300RX blinking.
Your transmitter battery may be getting low. If you have more than one KA300TX, change the batteries for all of them at same time. The battery should last for more than two years under normal conditions.
4.The battery LED on my KA300RX is blinking.
Battery back up on your receiver is getting low. Replace with new battery.
5.I moved to a different house and took KA300 system with me. The transmitter shows a wrong channel when I test it.
Change the channel jumper on the front of the transmitter KA300TX to the correct channel.
6.The KA300RX did not respond to my transmitter after I tried to program a new operation code to the memory. All three LEDs stay stable when reset. The memory is full. Reset the KA300RX and erase the memory by unplugging the battery and AC adapter. Test the KA300RX by plugging the battery back up. If the LEDs stay stable, leave the machine unplugged for longer than one minute before trying it again.
13
