Features

•Complies with IEEE 802.3u 100BASE-TX 100BASE-FX and IEEE 802.3 10BASE-T specifications

•2 switched ports:

Port 1 - 10/100M TP port

Port 2 - configurable 10/100M TP port or 100M Fiber port

•The TP ports support:

-auto speed sensing for 100Mbps or 10Mbps connection

-auto-negotiation with NWay devices

•Each TP port provides one MDI-X jack and one MDI jack for flexible connection to different devices using straight-through UTP cable.

•Each port has an individual manual setting for speed and duplex type configuration for connecting to non-NWay devices.

•Self-learning for network configuration

•Store and forward switching to ensure only good packets are forwarded

•Full-duplex or half-duplex operation support for both ports

•Forwarding and filtering at full wire speed

•Comprehensive LED indicators

•Attachable to metal surface via flexible rubber magnet

-2-

Image 6

Contents

Installation Guide 10/100 Bridging ConverterPage Trademarks Interpreting LED Indicators Table of Contents IntroductionInstallation Making Network Connections Introduction Features Standard SpecificationsConnectors Port 1 2 RJ-45 jacks FX LED for Port Installation guide Unit One AC power adapter for the switch InstallationInstallation Unpacking Checking AC Power Two switched ports are located on the front panel Two Switched PortsConfiguration Switches Factory Defaults Jack Function TP PortsImportant Note Pin assignments of the jacks are defined as follows Compliant UTP Cables Connected Device SW1 setting Port Operation ModeUTP Connections Connection UTP Cable Type Maximum Length Fiber Port and Fiber Connection Fiber Cables Required fiber cable for the connection areModel Series Applications Following table lists some applications using the deviceConnecting to Duplex type Maximum length Connected device Duplex type Maximum length Interpreting LED Indicators Following figure shows the locations of the LED indicators