LUBRICATION
3000STOPR005810R082503
ALWAYS STOP MIXER AND DISCONNECT POWER BEFORE SERVICING, REPAIRING, OR CLEANING. USE SAFE SHOP PROCEDURES AND EXERCISE CAUTION WHEN WORKING ON THIS MIXER!
It is extremely important that the following lubrication guide be followed:
For lubricating bearings, use a good quality multipurpose grease. Replace all damaged or missing grease zerks immediately. Always clean zerks before using grease gun. Pump the grease in slowly until a slight bead forms around the bearing seals. Once a month check lines and connections on grease banks for leaks.
Before operating a new mixer, the roller chains should be liberally lubricated and then the unit operated under a
The large drive enclosure is designed to be used as an oil bath; fill front enclosure until the oil level reaches the plug labeled “oil level ”on the enclosure.
LOCATION | DESCRIPTION | INTERVAL | LUBRICANT |
A | INPUT SHAFT BEARINGS | GREASE | |
B | AUGER BEARINGS (QTY 4 ALL MODELS) | GREASE | |
C | REEL BEARINGS (QTY 2 ALL MODELS) | GREASE | |
D | JACKSHAFT BEARINGS (3050,3060,3070,3095 ONLY) | GREASE | |
E | DOOR GUIDES | GREASE | |
F | DOOR LINKAGES | GREASE | |
G | ROLLER CHAIN TIGHTENER PIVOTS | YEARLY | OIL, 30WT |
H | ROLLER CHAIN (WITH 30WT OIL BATH) | OIL, 30WT | |
| CHECK OIL LEVEL PLUG |
|
|
I | ROLLER CHAIN (WITH 30WT OIL BATH) | 6 MONTHS | CHANGE OIL, USE |
|
|
| 30WT MOTOR OIL |
J | SCALE CHECK ARMS (3050,3060,3070,3095 ONLY) | OIL, 30WT | |
K | TOP OF PIN CHECK BEARING (3036,3042 ONLY) | OIL, 30WT | |
L | WEIGH BARS (3015, 3020,3025,3030 ONLY) | YEARLY | GREASE |
| LUBRICATION FOR OPTIONS |
|
M | 12 VOLT HYDROPACK |
* * * shields removed for illustrative purposes
KUHN KNIGHT INC. | 25 |
1501 West 7th Ave. Brodhead, WI |
|
701 Cherry Ave. Greeley, Co. 80632