8
WEEKLY:
*The
1.Remove front burner access cover.
2.Slightly back brass packing nut off (counterclockwise) to release
3.Slowly draw rod out until it stops while rotating 360 degrees several times. A small pair of pliers or vise grips may be helpful. This rod has a scraper internally that scrapes away carbon from inside the line.
4.While still rotating, push the rod back in until it stops and tighten the packing nut snugly.
5.Replace access panel.
*Note: If flame is burning lower than expected, you probably have carbon
SECTION 6
Trouble-shooting guide
CONDITION:
1.Oil present in burner with the carburetor in “off” position.
2.No oil in burner bottom after carburetor is turned on.
3.Flame smoky when lit.
4.Flame smoky when burning low.
5.Flame smoky when burning high.
6.Flame goes out on low.
7.Flame goes out in high winds.
8.Burner goes out and will not
9.Flame is noisy (buzzing or roaring) or separating from the burner on
10.Flame size seems lower than normal while on high.
11.Dirty or sooty glass.
12.Oil smell in room.
POTENTIAL PROBLEM:
1.
2.