La Crosse Technology WS-7215U-IT instruction manual Wall Mounting, Troubleshooting

B.WALL MOUNTING

1)Remove the table-stand. To do this, pull down on the stand from the rear and rotate forward.

2) Fix a screw (not included) into the desired wall, leaving approximately 3/16 of an inch (5mm) extended from the wall.

3)Place the Wireless Temperature Station onto the screw using the hanging hole on the backside.

4)Gently pull the Wireless Temperature Station down to lock the screw into place.

TROUBLESHOOTING

NOTE: For problems not solved, please contact La Crosse Technology.

Problem: No reception of WWVB time signal.

Solution: 1) Wait overnight for signal.

2)Be sure the Wireless Temperature Station is at least 6 feet from any electrical devices, such as televisions, computers, or other radio- controlled clocks.

3)Remove batteries for five minutes, reinsert and leave the unit alone overnight without pressing buttons.

4)If there are still problems, contact La Crosse Technology

Problem: Hour is incorrect (minute and date are correct)

Solution: Be sure correct time zone and daylight saving time settings are selected.

Problem: The LCD is faint

Solution: 1) Set the LCD contrast to a higher number 2) Replace batteries

Problem: No outdoor temperature is displayed.

Solution: 1) Remove all batteries, reinsert into remote temperature sensor first, then display.

2)Place remote sender closer to display.

3)Be sure all batteries are fresh.

4)Place remote temperature sensor and Wireless Temperature Station in position so the straight-line signal is not passing through more than two or three walls.

20