La Crosse Technology WS-8056U instruction manual Temperature Alarm

DETAILED SET-UP GUIDE

I)BATTERY INSTALLATION

Note: To avoid start-up problems make sure that the batteries do not spring free.

A)REMOTE TEMPERATURE SENSOR

1)Remove the battery cover. Place your thumb over the two air-vent slots on the face of the remote temperature sensor, push down gently, and slide battery cover down and off.

2)Observing the correct polarity, install 2 AA batteries. The batteries will fit tightly (to avoid start-up problems make sure that they do not spring free during installation).

3)Replace the battery cover.

B)TEMPERATURE ALARM

1)Remove the battery cover, located on the backside of the unit and directly below the function buttons.

2)Observe the correct polarity and install 2 AA batteries.

3)Replace the battery cover.

Note: After the batteries have been	Radio reception
installed a tone will sound, and all
the LCD’s (Liquid Crystal Display)	WWVB	Alarm
will briefly light up. The indoor
temperature, the date as “1/ 1”, the	Date	Outdoor temperature
weekday as “MON”, and the remote
temperature will be displayed (within	Weekday or	Indoor temperature or
three minutes). Also, the time will	seconds display	seconds display

appear as “-:--” for approximately 1

minute. The WWVB search is automatically initiated, and a tower icon appears and flashes with the time colon (no tower icon will appear if the WWVB is too weak to be detected, and the time display will remain on “-:--”). While the WWVB search is being conducted various numbers will appear in the time display. After 10minutes, the temperature alarm will either display the WWVB time, or discontinue the search if the time is not found. If the search is cancelled “-:--” will appear in the time LCD. The temperature alarm will conduct a WWVB search every hour until the first signal is found. Once the WWVB time is found, a search is automatically conducted nightly at midnight. If the signal is found at midnight, the tower icon will remain, if not, another search will take place every hour (until 6:00 am) until the signal is found successfully. If no signal is found during this period, the tower icon will not appear and the clock will search again at 12:00 am the next night.

5