F.REMOTE TEMPERATURE
1.The projection alarm comes with a remote temperature sensor. When set up properly, the projection alarm will receive and display the remote temperature.
2.It is important to power up the transmitter first, then the Projection Alarm. If batteries are removed in the remote, the projection alarm MUST be
3.The remote temperature is measured within the remote transmitter and transmitted to the projection alarm. If outdoor temperature is desired, simply mount the remote transmitter outside. It is recommended to mount the transmitter on the north side of the house away from sources of heat or cold (away from direct sunlight, windows, vents, etc.).
4.The range of the transmitter is 80 feet in open space. While the signal is able to penetrate walls, it will decrease the range. Concrete and metal structures offer the most resistance.
5.The transmitter should not be mounted on a metal surface.
6.The transmitter and projection alarm should be kept away from other sources of possible interference including cordless appliances (telephones, baby monitors), microwave ovens, and other strong electrical appliances.
7.The remote temperature is displayed in °F or °C, depending on the time format (12 or
G.TIME ALARM
The Projection Alarm has two separate alarms for time, “ALM1” and “ALM2”. The alarms have a different sound; ALM1 increases in volume after 25 seconds, and again after 50 seconds. ALM2 is a constant volume. The total duration is 96 seconds for each alarm.
1.SETTING THE ALARM
a.Press and hold “ALM1” OR “ALM2” for two seconds until the alarm time is flashing.
b.Press and release“ALM1/HOUR” to advance the hour, and “ALM2/MIN” to advance the minute. The time will display “PM” if set to PM, and nothing if set to AM.
c.The projection alarm will revert to normal operation when no buttons are pressed for 15 seconds. The alarm is now set and activated.
11
