Land Pride AFM4016 manual Models, 4014, Danger, Table of Contents

Table of Contents

Section 3: Adjustments

Center Deck Height Adjustments

!DANGER!

Before making adjustments or performing maintenance on your mower, disengage PTO, shut off tractor and wait for all moving parts to stop before dismounting tractor. Disconnect the PTO driveline.

!CAUTION!

Block the decks before making cutting height adjustments.

so the main frame is level to the ground. Tire pressure will affect mowing height. Be sure all tires have the proper pressure as listed in the Tire Inflation Chart under the “Appendix” section on page 46.

Refer to U-Joint Timing and Transporting in the “Operating Instructions” on page 16 for instructions on raising and lowering the decks before continuing.

1.Raise the decks up to an adequate height and block under the decks to prevent them from falling during gauge wheel height adjustments. Locate equal number of spacers below the spindle tubes on all 10 gauge wheels. see also note after this step.

These adjustments should be made with the mower hooked up to the same tractor that will be used for field operations or one having the same drawbar height. Position the mower on a level surface and hitch adjusted

•Refer to Figure 3-1for Minimum Cutting Height Set- up and Maximum Cutting Height Set-up.

•Refer to the Cutting Height Chart on this page for a guide on measuring cutting height.

	12716
	12717
Approximately 1” for Model 4011	Approximately 5 1/2” for Model 4011
Approximately 3/4” for Models 4014 & 4016	Approximately 5 1/4” for Models 4014 & 4016
Minimum Cutting Height Set-up	Maximum Cutting Height Set-up
	Figure 3-1

Cutting Height Chart					12742
4011 Models			4014 & 4016
A		B	A	B
4 7/8"		1"	4 5/8"	3/4"
5 3/8"	1	1/2"	5 1/8"	1 1/4"
6 3/8"	2	1/2"	6 1/8"	2 1/4"
7 3/8"	3	1/2"	7 1/8"	3 1/4"
8 3/8"	4	1/2"	8 1/8"	4 1/4"
9 3/8"	5	1/2"	9 1/8"	5 1/4"

20 AFM4011, AFM4014 and AFM4016 All Flex Grooming Mowers 315-160M 7/28/06