Land PrideTable of Contents
Section 5: Maintenance and Lubrication
6.(Model 1416 Only.) Reinstall the two outside bolts. Tighten to correct torque listed in the Torque Values Chart in the “Appendix” section on page 46.
22374 |
Models 4011 & 4014 Shown |
Blade & Blade Bar Removal
Figure |
22373 |
Models 4016 Shown |
Blade & Blade Bar Removal
Figure
Blade Sharpening
!CAUTION!
ALWAYS wear eye protection and gloves when sharpening a blade.
NOTE: Care should be taken in order not to remove any more material than necessary to sharpen blade.
1.If the blade cutting edge is dull or nicked, it should be replaced or sharpened.
2.Clean blade, blade washer and mounting surface of all debris before replacing or sharpening.
3.Grind cutting edge at the same bevel as the original. See Figure
19327
Blade Sharpening
Figure
4.Check blade balance by positioning the blade horizontally on a nail or shaft through the center hole. See Figure
HORIZONTAL
NAIL OR SHAFT
19046
Blade Balancing
Figure
Blade Options:
•Low Lift Blades - For use in sandy soils
•Mulching Blades - For leaf mulching
7/28/06 | AFM4011, AFM4014 and AFM4016 All Flex Grooming Mowers |