12 FDR2572 & FDR2584 Grooming Mowers 310-262M

Table of Contents

Section 1: Assembly and Set-Up

e.Cut off inner shield at mark (“X” dimension). Cut same amount off inner shaft (“X1” dimension). Repeat cut off procedure (“Y” & “Y1” dimensions) to cut outer driveline half.

f.Remove all burrs and cuttings.

5.Apply multi-purpose grease to the inside of the outer driveline profile and reassemble the two profiles.

6.Attach inner driveline yoke to gearbox shaft and outer driveline yoke to tractor's PTO shaft.

7.The driveline should now be moved back and forth to insure that both ends are secured to the PTO shafts. Reattach any end that is loose.

IMPORTANT: The two supplied safety chains must be attached to outer and inner driveline yoke shields and to the mower deck and tractor to keep driveline shields from rotating.

8.Hook one driveline safety chain in the hole on the outer driveline yoke shield and the opposite end to the tractor.

9.Hook the second driveline safety chain in the hole on the inner driveline yoke shield and the opposite end to the mower.

10.Start tractor and raise mower just enough to remove support blocks used in step 4a on page 11.

11.Slowly engage tractor’s 3-point controls to lower mower. Check for sufficient drawbar clearance. Move drawbar ahead, aside or remove if required.

Land Pride