Land Pride PS1548 Pre-Assembly Checklist, Sling Bracket, Assembly and Set-up, Table of Contents

Table of Contents

Section 1: Assembly and Set-up

Pre-Assembly Checklist

Check	Reference
All major frame components	Operator’s
	Manual
Fasteners and pins that were	Operator’s
shipped with the seeder.	Manual
NOTE: All hardware from the
factory has been installed in the
location where it will be used. If a
part or fastener is temporarily
removed for assembly reasons,
remember where it goes.Keep the
parts separated.
All working parts are moving freely,	Operator’s
bolts are tight and cotter pins are	Manual
spread.
If a pin, bolt or other part has been	Operator’s
removed, and you are unsure	Manual
where it is used, use the parts
section of this manual to identify it.
Be sure the part gets used in the
correct location. By double
checking while you assemble, you
will lessen the chance of using a
bolt incorrectly that may be needed
later.
All grease fittings are in place and	Section 5
lubricated.	Page 20
Proper tension and alignment on all	Operator’s
drive chains.	Manual
Safety decals are correctly located	Important
and legible. Replace if damaged.	Safety
	Information

Sling Bracket

Refer to Figure 1-1:

The sling brackets allow points at each end to hook the chain for lifting of the unit.When hooking the chain to the sling brackets, be certain to either use a spreader bar on the chain or use a long chain to prevent bending the sling brackets.

21492

Sling Brackets

Figure 1-1

6 PS1548 & PS1572 Primary Seeder 313-164M 7/22/05