Landice 72070 manual Assembly Instructions, Do not cut through, Center of the box, as you could

Assembly Instructions

STEP 1:	STEP 2:	STEP 3:
Unbolt treadmill from pallet	Cut the box off the pallet	Unstrap the treadmill

• On L7 treadmills it is necessary	• Remove the metal strapping	• The treadmill components
to remove the bolts which hold	around the box.	are held together with plastic
the treadmill to the pallet.	• Using a razor blade knife, cut the	strapping.
• Start by removing the top bolts.	box just above the bottom row	• Carefully cut and remove the
• Lay the treadmill on the ground,	of brass staples along all sides	strapping. Remove the treadmill
and then remove the bottom	of the box.	upright and accessory boxes
bolts by placing the treadmill on	• DO NOT cut through the	from the treadmill. Lift the
your toolbox.	center of the box, as you could	treadmill off the pallet.
• With the bolts removed, the	damage the treadmill.	• Carefully remove the upright
treadmill will be free to move	• Remove the box and discard.	side cover from the upright
around in the box.		assembly.

STEP 4:

Secure upright to frame

•Slide the upright down onto the 8-side frame bolts.

•Tighten bolts with a 7/16” extended socket.

STEP 5: Prepare to install hand

rails (Med Rails: the word handrails refers to the 4” clamps for steps 5-8)

•The handrail mounting bolts have been threaded into the rails for shipping. Remove them.

•Attach both handrails by first hand-starting the bolts through the upright and then using a 1/2” socket. Leave about 1/8” of slack.

(DO NOT TIGHTEN FLUSH TO SURFACE).

STEP 6:

Place crossbar

•After mounting both handrails, gently lower the curved crossbar into position between them.

•Each end of the crossbar should cover the two smaller access holes that are cut into the handrails.

•Leave contact heart rate connection harness hanging for now.

STEP 7:

Secure crossbar

•Using an extended 1/2” socket, carefully guide the 2 inch bolt with lock washer into the big access hole in the side of the handrail.

•Once the bolt reaches the crossbar, tighten it.

•Repeat this step with the other handrail.

STEP 8:

Secure hand rail

•Press the dome plugs into the large access holes on the side of the handrails.

•Finish tightening the handrail bolts from STEP 5.

•Note: Med Rails go to Appendix A on page 30.

2