Removing/Installing The Spartan Brake Pad Only (FIGURE 3)
1.Remove the tire. Perform the following as shown in DETAIL “A” of FIGURE 3:
A.Remove the cap covers from both sides of the tire.
B.Remove the screw and locknut that secure the tire to the rollator.
C.Remove the tire.
2.Remove the phillips screw securing the brake pad to the plunger assembly as shown in FIGURE 3.
3.Remove the brake pad from the rollator.
4.Align the mounting holes of the NEW brake pad and plunger assembly, as shown in FIGURE 3.
5.Install the phillips screw. Tighten securely.
6.Reverse STEP 1 to reinstall the tire
Cap Cover
DETAIL “A”
Tire
Locknut
Screw
Cap Cover
Mounting
Hole
Plunger
Assembly
Brake Pad
Phillips Screw
FIGURE3-REMOVING/INSTALLINGTHE
SPARTAN BRAKE PAD
Replacing Spartan Brakes (FIGURE 4)
1.Remove the brake pad. Refer to REMOVING/IN- STALLING THE SPARTAN BRAKE PADS in this pro- cedure of the instruction sheet.
2.Remove the plunger assembly. Perform the following:
A.Pry the plunger assembly out of the rollator leg with a flat screwdriver.
3.Remove the EXISTING brake wire stop. Perform the following:
A.Depress and hold the plunger (small end of the plunger assembly).
B.With a flat screwdriver, pry the EXISTING brake wire stop up over the lip of the insert.
C.PulltheEXISTINGbrakewirestopdowntopullthe brake wire through the slot in the lip of the insert.
4.Disassemble the plunger assembly. Perform the fol- lowing:
A.Remove the insert from the plunger.
B.PositiontheEXISTINGbrakewirestopintotheopen- ing in the plunger slot.
C.Slide the spring off the plunger.
D.RemovetheEXISTINGbrakewirefromtheplunger.
5.PulltheEXISTINGbrakewireandcableUPthroughthe rollatorleg.
6.ThreadtheendoftheNEWbrakewireandcableDOWN intotherollatorleg.
7.Assemble the plunger assembly. Perform the following:
A.Insertthe NEWbrakewirestopintotheslotopening intheplunger.
B.Ensure NEWbrakewireis positioned intheplunger slot as shown in FIGURE 4.
C.Slide the spring onto the plunger.
D.Slide the small end of the insert onto the plunger.
8.SecuretheNEWbrakewirestop.Performthefollowing:
A.Align the slots on both the plunger and the insert.
B.Grasp and hold the wire stop.
C.Depress and hold the plunger.
D.Pullthewirestopupthroughtheslotintheinsertand overthelip.
9.Insert the plunger end of the plunger assembly into the rollatorleg.
NOTE: A rubber mallet may be necessary to ensure the plunger assembly is fully inserted into the rollator leg.
10.Reinstallthebrakepad.RefertoREMOVING/INSTALL- ING THE SPARTAN BRAKE PADS in this procedure of the instruction sheet.
11.AssembletheSpartanrollatorforuse.RefertoASSEM- BLING THE SPARTAN FOR USE in this procedure of the instruction sheet.
5
