REMOVING/
INSTALLING THE
PLUNGER
ASSEMBLY
-STEPS 2 AND 9 Rear Frame
Flat
Screwdriver
Plunger
Assembly
REMOVING/SECURING THE
BRAKE WIRE STOP
- STEPS 3 AND 8
LipPlunger
Flat
Screwdriver
Insert
Brake Wire Stop
Slot Opening Slot
DISASSEMBLING/ASSEMBLING THE PLUNGER
ASSEMBLY - STEPS 4 AND 7
|
| Brake |
|
Plunger | Spring | Wire Slot Brake | Slot |
| Wire | Opening | |
|
| ||
|
| Stop |
|
REMOVING/INSERTING
THE BRAKE CABLE
- STEPS
Brake
Cable
Rear Frame
Insert
FIGURE4 -REPLACINGSPARTANCANESANDBRAKES-REPLACINGSPARTANBRAKES
Assembling Spartan For Use (FIGURE 5)
NOTE: The Spartan rollator should only be assembled AFTER replacing spartan brakes. Refer to REPLAC- ING SPARTAN BRAKES in this procedure of the in- struction sheet.
1.Install tire. Perform the following:
A.Position the tire so the mounting holes are aligned with the mounting holes in the rollator leg.
B.Install the screw from the inside of the rollator, through both sets of mounting holes.
C.Secure the tire to the rollator with the locknut. Tighten securely.
D.Install the cap covers over the screw and locknut.
2.Perform one (1) of the following:
INSTALLING CANE KIT - Install the push handle. Per- formthefollowing:
A.Remove the hex bolt, washer and locknut securing thehandbraketothepushhandle.
6
