ADJUSTING STINGRAY AND STARGAZER HAND BRAKES (FIGURE 10)
Adjusting Hand Brake
NOTE: COUNTERCLOCKWISE/CLOCKWISE direc- tions are determined by standing behind the rollator (us- ers position).
1.Loosen the hand brake adjustment nut by turning
CLOCKWISE.
2.Perform one (1) of the following:
A.Loosen hand brake tension - turn hand brake nut COUNTERCLOCKWISE.
B.Tighten hand brake tension - turn hand brake nut CLOCKWISE.
3.Turn the hand brake adjustment nut CLOCKWISE to secure in place.
4.Perform one (1) of the following:
A.Acceptable tension - repeat STEPS 1 - 3 for op- posite side, if necessary.
B.Unacceptable tension - refer to ADJUSTING CASTER HOUSING in this procedure of the in- struction sheet.
5.Refer to LOCKING/UNLOCKING/USING HAND BRAKES in the Stingray/Stargazer instruction sheet Part Number 1076167.
Adjusting Caster Housing
1.Turn the caster housing nut on the bottom COUN- TERCLOCKWISE to loosen.
2.Turn the caster housing adjustment nut COUNTER- CLOCKWISE to loosen.
3.Retighten caster housing adjustment nut and caster housing nut by turning CLOCKWISE.
4.Repeat STEPS 1 - 3 until tension is acceptable.
|
| REPLACING BRAKE CABLE |
REPLACING BRAKE WIRE/ | Guide | |
ADJUSTING CASTER HOUSING | ||
| Brake Cable | Frame |
| Caster Housing | Brake |
| Adjustment Nut | |
Brake | Caster Housing | Cable |
| ||
Brake Wire Nut
Hex Screw | REPLACING/ADJUSTING HAND BRAKE |
|
|
| Push | Phillips Screw | |
|
|
| Mounting | |
|
| Handle |
| |
|
|
| Hole | |
REPLACING/ADJUSTING PUSH HANDLE | Hand |
| ||
| Back Support | |||
|
| Brake |
| |
|
|
|
| |
| INSIDE |
|
| Hand Brake |
Push |
|
|
| Adjustment |
|
| Hand | Nut | |
Handle |
|
| Brake Nut |
|
|
| Push | Hand |
|
|
| Handle | Brake | Back Support |
Adjustment |
|
|
|
|
Knob | Screw |
|
|
|
| Frame |
|
|
|
OUTSIDE
FIGURE 10 - REPLACING/ADJUSTING STINGRAY AND STARGAZER BRAKES/
ADJUSTING STINGRAY AND STARGAZER PUSH HANDLE
11
