Power Cord | The cord used to connect the copier to the power receptacle. The plug |
| design is specified depending on the amount of power the copier requires. |
| Make sure the receptacle is the correct one for your copier. |
READY Indicator | This is an indicator that shows when the copier has warmed up and is |
| ready to make copies. It appears in several forms; a light, an icon, and the |
| message itself. |
Release Lever | The lever located inside the Front Cover used to release the Upper Unit |
| for access to the paper path. |
Sample Key | This key allows you to run a sample copy set using the finisher. |
Separation Corona | One of the Coronas inside the copier. It is usually located near the Drum |
| and separates the paper from the Drum. Because it attracts the toner, and |
| since it is located below the paper, it has a tendency to get dirty. This can |
| require the Key Operator to either clean the coronas or call for service. |
Sheet Feed Bypass | A tray that opens from the side of the machine, usually just above the |
| Primary Paper Tray or LCC. It is designed to feed a single sheet at a time. |
| This tray can be used to feed paper or transparency stock that would |
| normally not be placed in the Feed Drawers. Since it bypasses the normal |
| paper feeding mechanism and feeds straight through the paper path, |
| heavier stocks (like cover stock) feed better. |
Sorter | An accessory attached to the output of a copier designed to perform a |
| sorting function. The sort function allows you to make multiple copy sets |
| of an original in such a way that the pagination matches the original |
| document. |
Stack Feed Bypass | A tray that opens from the side of the machine, usually just above the |
Feed Tray | LCC or Primary Paper Tray, and is designed to feed a stack of paper. This |
| tray can be used to feed paper or transparency stock that would normally |
| not be placed in the Feed Drawers. Since it bypasses the normal paper |
| feeding mechanism and feeds straight through the paper path, heavier |
| stocks (like cover stock) feed better. |
Stack Key | This key is used to program the Stack functions. This is available only if a |
| Sorter or Finisher is present. In the stack mode, multiples of a single page |
| of a document are placed in separate Sorter Trays or are offset in the |
| Finisher Tray. |
Start Key | This Key is used to start the copying process once all selections have been |
| made. On a Lanier copier, it is always green in color. |
Toner | The black powder that is used to form the image on copy paper. In a color |
| copier, it would be colored. PLEASE NOTE: Toners are designed to |
| operate specifically in a copier and differ greatly on the copier |
| requirements. Toner from other copiers should never be mixed. At best, |
| the image would be too light or too dark. At worst, it can damage your |