B: Uploading Firmware

B: Uploading Firmware
You may upload new versions of firmware using File Transfer Protocol (FTP). This
allows access to new firmware releases for firmware improvements and new features
additions.
Note: To begin an FTP upload session, you must first configure the FTP Host
address, username/password, filename and file path. For information on configuring
the FTP settings required for firmware upload see 3:Operations.
You may initiate an FTP upload session by issuing a command or from the web
browser interface. You must have administrator-level privileges to initiate an upload.
To initiate an FTP upload session from the web browser interface
1. On the Restart page in the Tools section of the web browser interface, select
Restart and upload firmware via FTP from the drop-down menu and press
Apply.
2. Upon issuing this command the unit will restart and upload the firmware file
specified with the FTP Filename command from the previously configured FTP
Host. See FTP Administration on page 62 for more information.
To initiate an FTP upload session from the command line
The Restart FTPLoad command initiates an upload of firmware. Upon issuing this
command the unit will restart and upload the firmware file specified with the FTP
Filename command from the previously configured FTP Host. See FTP
Administration on page 62 for more information.
To initiate an FTP firmware upload session:
1. At the command prompt, type restart ftpload and press Enter.
SecureLinx SLP Remote Power Manager 100