Mechanical Time Recorder User’s Guide
Page 12
Figure 9
The 2000-BATT requires four “D” size ba tteries and should
operate for six months before replacem ent. An internal
beeper sounds momentarily each minute when the batter y
supply discharges below 4.5 volts. Replace batter ies as
follows when this occurs:
1. Pull and rem ove the front two rubber feet underneath the
unit.
2. Loosen, 1 to 2 turns, the two phillips-head screws located
1.5 inches directly inside the rubber feet mounting holes.
3. Slide the bottom battery compartment outward ( to front)
and down, to get to the batteries. (See Figure 9.)
4. Replace the four “D” size batteries. Be sure the batteries
are installed with proper polarity (+/-) as marked on battery
holder.
5. Re-install the battery compartment on the bottom of the
recorder, aligning the holes with the screws. Press the
compartment firmly to the back (inward), tighten the two
Phillips-head screws, and re-insert the two rubber feet.