13 - LT Series Operations Manual
CHANGING THE PLATEN
1.Disconnect the power source.
2.Remove the top cover. Remove the frame locking pin and lift the top frame. Remove the ribbon (see Changing the Ribbon, Page 11).
3.Lift the printing platen assembly up and out of the frame. (Fig. 10)
4.Insert the alternate printing platen assembly, using the guide pin for alignment.
5.Replace the ribbon. Close the top frame and install the frame locking pin. Install the top cover.
6.Connect the power source.
7.Make a sample registration. Reset the time type wheels and the digital display.
Figure 10
