IBM DS-2000 warranty Installation XI. Installation, XII Specifications

INSTALLATION

XI. INSTALLATION

M a k e s u r e t h e r e i s a c o p y o f t h e original reference diskette available. T h i s d i s k e t t e m u s t b e m o d i f i e d t o accept any option adapters.

1.Turn unit off.

2.Remove system cover as instructed in the IBM Quick Reference Guide.

3.Insert adapter into any vacant slot following the guidelines for installing an optional adapter in

the IBM Quick Reference Guide.

4.Replace system cover.

5.Turn unit on and insert copy of reference

diskette into drive A.

6.Respond "N" to automatic configuration.

7.Select "Copy an option diskette" and follow copying instructions.

8.Select "Set configuration"

9.Select "Change configuration" or "Run automatic configuration" and follow instructions.

After the initial installation, the reference diskette w i l l c o n t a i n t h e c o n f i g u r a t i o n f i l e f o r t h e D S - 2 0 0 0 . Subsequent re - installation or address changes may omit s t e p 7 a n d a " Y " r e s p o n s e m a y b e g i v e n i n s t e p 6 (automatically configure system) if desired.

XII.		SPECIFICATIONS
Bus interface:					IBM MicroChannel 16-bit bus
Controllers:					2 - 16550 Asynchronous Communication
							Elements (ACEs)
RS-422	interface:				2 - D-9 connectors (female)
Transmit drivers: MC3486 or compatible
Receive buffers:					MC3487 or			compatible
I/O Address range: See figure 17
Interrupt		levels:			IRQ 3,4,7,9
Power	requirements:
		+--------			+--------		+-----------			+
			I	T		I MS			Supply
		+--------			+--------		+-----------			+
			630mA			720mA		+5	Volts
			--			--		+12	Volts
			--			--		-12	Volts
		+--------			+--------		+-----------			+
	I T		-	Typical		adapter		current
	I MS		-	Maximum		statistical			adapter current

iii