Lathem LTN, LTTNC, LTD, LT Series, LTTC user manual Setting the Digital Display

7 - LT Series Operations Manual

SETTING THE DIGITAL DISPLAY

Models with a "C" affixed to their designation (LTTC and LTTNC) denote units featuring a digital display. This display is factory-set for use in the 12-hour AM/PM format or the 24-hour (Continental) format. The digital display should always be synchronized with the time type wheels. To set the digital display and synchronize the display with the time type wheels, do the following:

1.Connect the power source.

2.Locate the three (3) push-buttons labeled SEC, HRS and MIN on the bottom of unit (Figure 3).

Figure 3

3.Return the unit to its upright position with the digital display facing towards you. Pull the unit forward slightly so the front hangs over the edge of the table, thereby giving you access to the buttons. (Remember: The minute button is on the right.)

4.Make a registration to see what time is indicated by the time stamp. Use the HRS (center) and MIN (right) buttons to set the time to the hour and minute indicated on the registration.

5.Place your finger on the minute button (right) but do not press it just yet. Listen for the type section to advance; you will hear an audible click. When you hear the click, immediately press the minute button to advance one minute. Seconds are now synchronized with the type section.

6.Make another registration to check the imprint feature for accuracy.

(Note: Interruptions in power lasting more than 3 to 5 seconds will cause the digital display to flash, indicating that it is necessary to reset the display.)