TROUBLE SHOOTING

Before going through the check list, finish wiring connection. If there still are any question after finish testing the items in the following list, consult your nearest service dealer.

Symptom

Cause

Solution

 

 

 

The compact

The volume control is turned

Turn up the volume control.

disc or tape

down.

 

does not play

 

 

The power connections are not

Check the +12V and ground

when inserted

wired correctly.

connections.

into the unit.

 

 

The sound from

The road surface is rough.

Wait for the road surface to

the CD player

 

improve before playing a disc.

skips.

 

 

The unit is not mounted

Install the unit securely. Be sure to

 

 

securely.

use the rear strap if the vehicle

 

 

does not provide support for the

 

 

rear of the unit.

 

 

 

 

The disc is defective.

Try another disc. If it plays properly,

 

 

the first disc may be defective.

 

The disc is dirty.

Clean the disc.

 

 

 

No power.

The vehicle ignition is switched

Switch the ignition to the "ON" or

 

off.

"ACC" position.

 

 

 

 

The fuse is blown.

Replace the fuse with another 15A

 

 

fuse.

 

 

 

The unit does

The microcomputer has been

Eject the disc or tape, then insert it

not work

affected by electrical noise.

again.

properly (Eject,

 

 

 

Turn the power off and then on

Load, Play).

 

 

again.

 

 

 

 

 

No radio

The antenna cable is not

Insert the antenna cable firmly into

reception.

connected.

the antenna jack on the unit.

 

 

 

The radio does

The signals are weak.

Select a station using manual tuning.

not stop on any

 

 

stations when

 

 

automatic

 

 

tuning is used.

 

 

 

 

 

9.TUNE/SEEK/TRACK UP OR DOWN, FF/RW BUTTONS

In radio mode, press UP or DN button, it will start automatic tuning and stop at the next receivable station; press UP or DN button for more than 2 seconds to research for the higher or lower frequency station.

In tape mode, press UP or DN button to fast forward or rewind the tape, and press TAPE button to resume normal tape playing.

In CD player or CD changer mode, press UP or DN button to skip to the beginning of the next track or one of the track currently playing. Press DN button twice to skip to the beginning of the previous track. Press and hold UP or DN button for more than 2 seconds to search quickly (with sound) in the forward or reverse direction, and press it again to resume normal playing.

10-11-12-16-17-18. 1-6 PRESET MEMORY BUTTONS

Select the desired band, then tune for the station you want to store in memory, and then press and hold one of 1-6 preset memory buttons for more than 2 seconds to store the broadcasting station to the preset memory. Every preset memory button can be stored only one station for each band, so the car audio system can be stored 30 stations.

After finishing the storing operation, select the desired band and then press one or the six preset memory buttons to quickly tune for the desired station.

10.AMS BUTTON(Automatic Music Select System)

In tape mode, press AMS button to turn on the AUTOMATIC MUSIC SELECT SYSTEM. Then if you press FF or REW button, it allows you to skip forward or backward to the beginning of a particular selection.

Press AMS button again to cancel AMS mode.

11-12. DISC SELECTING BUTTONS

In CD changer mode, press the DISC + button to select the next disc and the DISC - button to select the preceding disc.

Page 3
Image 3
Legacy Car Audio LCDCS94 instruction manual Trouble Shooting, TUNE/SEEK/TRACK UP or DOWN, FF/RW Buttons