Legacy Car Audio LDVD52 Example 2Set sound mix output mode, Example 3 Coaxial output

System setting

2.Push [RIGHT] to enter the sub-menu in the sub-menu in the right screen. If you want to set the screen to "WIDE", firstly push [DOWN] twice to move the high lighting band to "WIDE' item, then push [ENTER],

3.Push [MAIN PAGE] to exit system setting.

Notes:three screen ratio modes, i, e, 16:9 WIDE, 4:3 PS, 4:3 L are available for your selection to enable different discs to match TV. the relationship between the video of disc and screen ratio mode are as follows:

Video of disc normal 4:3PS 4:3LB 16:9

4:3

16:916:9

Example 2:Set sound mix output mode

1.Push [SETUP] to enable TV screen display system setting menu picture, push [DOWN] to move the high lighting band to the item "SPEAKER SETUP", push [ENTER], TV screen will display

2.Push [RIGHT] to enter the sub-menu in the right screen, If you

want to set the sound mode to "STEREO", firstly push [DOWN]

System setting

once to move the high lighting band to "STEREO" item, then

push [ENTER].

3,Push [MAIN PAGE] to exit system setting page.

Example 3: Coaxial output

If the user use coaxial terminal to output audio signal, you need to set the audio output "SPDIF/RAW' or "SPDIF/PCM", you can operate following these procedures:

Push [SETUP] to enable TV screen display system setting menu picture, please firstly enter general setting sub-menu,then select the item "AUDIO OUTPUT" in the menu, then push [ENTER], TV screen will display:

2.Push [RIGHT] to enter the sub-menu in the right screen, push [DOWN] to move the high lighting band to the item "SPDIF/RAW" or "SPDIF/PCM",then push [ENTER].

3.Push [MAIN PAGE] to exit system setting.

Special indications: if you are not going to use coaxial output audio signal, you need to set audio output to "ANALOG' output, so there will be no audio signal to set audio output to "ANALOG" output, so there will be no audio signal to be output in the mixchannel.

16 17