Leica 764555, 764558 manual Indirect measurement with tilt sensor

the summary line, the partial results in the secondary line.

Press this button and trigger the measurement

. After the first

Press and hold the

key to display additional information about the

measurement the value is adopted.

and

measurement of the angles of the triangle

.

Triggers the measurement

. After the second measurement the

Indirect Measurement - determining a distance using 3

value is adopted.

measurements

Press and hold down this button to trigger continuous measurement

See figure {Q}

. Sweep the laser up and down over the ideal target point.

Press this button twice; the display shows the following symbol

.

Press this button to end continuous measurement. The result is

The laser is switched on.

displayed in the summary line, the partial results in the secondary lines.

Aim at the upper point (1) and trigger the measurement. After the

Press and keep pressed the

key to display additional information

first measurement the value is adopted. Keep the instrument as horizontal

about the measurement of the partial lengths

and

.

as possible

Press and hold down this button to trigger continuous measurement

Indirect measurement with tilt sensor

, sweep the laser up and down over the ideal target point.

Tilt measurement

Press to stop continuous measurement (2). The value is adopted. Aim

)

During tilt measurement the instrument should be held without a

at the lower point and

transverse tilt (max. 10°).

If the device is tilted by more than ± 10° laterally, the display

press this button to trigger the measurement (3)

. The result is

) shows infocode i 156 which means that the device has been tilted

displayed in the summary line, the partial results in the secondary lines.

too much.

Press and hold the

key to display additional information about for

)

The units of inclination are set in the menu.

example the partial distances

,

and the minimum distance

.

symbol

Press this button once to activate the tilt sensor. The

Indirect measurement - determining a partial value using

appears in the display. The tilt is continuously shown as ° or % depending

3 measurements

on the setting.

See figure {R}

Press to measure the inclination and the distance. See figure {L}.

e.g. determining the height between point 1 and point 2 using three target

Direct horizontal distance

points.

Press this button twice and the following symbol appears in the display

Press this button three times ; the display shows the following

.

symbol

. The laser is switched on.

Press this button to measure tilt and distance. The summary line

Aim at the upper point (1).

displays the result as the direct horizontal distance.

Leica DISTO™ D8 LCA782205a gb

13

Functions

GB