Leica 798056, 772789-R Set-up for ceiling work, Set-up for layout or floor work Roteo 20HV/35/35G

To use the laser for inclined planes:

XSet the laser in vertical mode, preferably on a tripod. If setting on the ground, flip down the support plate for stability.

XAfter the laser has self-leveled, set in manual or semi- automatic mode.

XLoosen the knobs on either side {D-1}to partially separate the mount from the laser.

XMove the laser to the approximate inclined position and tighten slightly.

XMove to the final position and tighten further. See illus- tration {K} in the back, inside cover of this manual.

Set-up for ceiling work

The Roteo is perfect for the leveling of suspended ceil- ings when used together with the wall mount and magnetic ceiling grid target.

To attach the laser and wall mount to the first piece of perimeter ceiling grid (Roteo 20HV/35/35G):

XFlip down the support plate {D-8}

XRelease the clamp {D-2}on top of the adjustable plate {D-3}.

XLock the clamp against the ceiling grid.

XIf the foot on the support plate is not touching the wall, use the screw {D-9}to adjust.

To move the laser up or down (Roteo 35/35G):

XTurn on the laser and wait for it to self-level. The head must be rotating before you can enter motorized mount mode.

XPress the motorized mount key {B-5}to activate the mount. The motorized mount LED {B-11}will turn on to indicate that the mount is now active.

XTo raise the motorized mount press the Plus key {B-9}. Press the Minus key {B-8}to lower motorized mount. Holding the key will result in fast movement; short clicks will move the laser more precisely.

Getting to work:

XRaise the laser on the wall mount until the rotating beam is at the same level as the perimeter ceiling grid. Use the line created by the laser as a reference to attach the perimeter grid to the wall.

XLower the laser on the wall mount until the rotating beam is striking the on-grade position on the magnetic, ceiling grid target.

XAdjust the height of the ceiling grid using the laser beam on the target as your reference. See illustration {G} in the back, inside cover of this manual.

Set-up for layout or floor work (Roteo 20HV/35/35G)

The Roteo can easily be used in the laydown or vertical mode for laying out walls locations, transferring points from the floor to the ceiling and plumb applications.

To use the laser in the vertical mode:

XFlip down the support plate {D-8}and place the laser in vertical mode on the floor.

XIf the support plate is not level, use the screw {D-9}to adjust.

XSet up the laser over a control point by first pointing the stationary beam downward, and then manually, or

EN

Roteo 20HV/25H/35/35G - 1.2.0en

8

Set-up and applications