![](/images/new-backgrounds/1209371/20937129x1.webp)
Checking vertical accuracy
To check the vertical accuracy of your laser, place the unit in the laydown position on a flat, level surface approximately
XHang a plumb line on the wall.
XMove the laser until the vertical, rotating beam is aligned to the plumb line.
XIf the rotating beam is not plumb, adjustment is neces- sary.
remote for this adjustment will make the job easier by not disturbing the laser.
After completing the changes to the
XPress the Plus key
XPress the Minus key
XPress the On/Off key
EN |
|
|
| Adjusting level accuracy – The |
| |||
| Adjusting level accuracy – The |
| |||||
| After checking the accuracy of your laser, perform the |
| After checking the accuracy of your laser, perform | ||||
|
| the following steps to adjust the accuracy of the Y- | |||||
| following steps to adjust the accuracy of the |
| axis. | ||||
| X Turn off the laser. |
| X If already in adjustment mode for the | ||||
| X Press and hold the Auto/Manual key |
| Plus key | ||||
| the On/Off key |
| axis. | ||||
| X After the X and Y LED’s blink three times simultane- |
| X If not in adjustment mode, follow the steps above for | ||||
| ously, release the Auto/Manual key. |
| entering adjustment mode, then press the Plus key to | ||||
| • The |
| switch to the adjustment of the | ||||
| leveling. |
| • The | ||||
| • The |
| leveling. | ||||
| for adjustment. |
| • The | ||||
| • The head will not be rotating. |
| for adjustment. | ||||
| • To use a receiver, press the Scan/Rotation key |
| • The head will not be rotating. | ||||
|
| • To use a receiver, press the Scan/Rotation key | |||||
| X Press a CCW/CW key |
| |||||
| Roteo 20HV} to adjust the beam up or down. Five |
| X Press a CCW/CW key | ||||
| presses of the key will move the beam approximately |
| Roteo 20HV} to adjust the beam up or down. Five | ||||
| 1.5 mm at 30 meters (1/16" at 100 feet). Use of the |
| presses of the key will move the beam approximately | ||||
|
|
|
| 1.5 mm at 30 meters (1/16" at 100 feet). Use of the | |||
|
|
|
|
|
|
|
|
Roteo 20HV/25H/35/35G - 1.2.0en |
| 12 |
| Check and Adjust |
| ||
|
|
|
|
|
|
|
|