HEARTH PRODUCTS KITS AND ACCESSORIES
P/N 750,251M REV. A 01/2008
REFLECTIONS REMOTE CONTROL REPLACEMENT KIT
INSTALLATION INSTRUCTIONS FOR THE REFLECTIONS REMOTE CONTROL
REPLACEMENT KIT (KIT NUMBERS: H1454 AND H6977)
GENERAL INFORMATION
This Remote Control Replacement Kit is to be used to replace the Reflections Electric Fireplace’s Remote Control. The kit components are shown below.
(Kit Number H1454 And/Or H6977)
REPLACEMENT INSTRUCTIONS
Note: Depending on the type of control board in your fireplace, the number of steps and components may vary. Following are the types of control boards for identification:
If you have Kit Number H1094, it will be necessary to replace the board and IR cables. In this case, complete all the Steps as outlined in these instructions.
If you have Kit Numbers H1454 or H6977, it is not necessary to replace the IR cables. In this case, skip Steps 11 through 21 and complete the remaining process as outlined in these instructions.
Refer to the Reflections Fireplace Installation Instructions manual (No.
850,091M) for a visual aid on the following steps:
Step 1. Disconnect the electrical power to the fireplace.
Step 2. Remove the doors from the fireplace.
Step 3. Remove the reflective glass.
Step 4. Remove the logs.
Step 5. Remove the grate.
Step 6. Remove the ember bed.
Step 7. Remove the fireplace floor.
Step 8. Remove the DVD player. Make sure to label the “Video Out” and “Sound Out” cables when disconnected from the DVD player.
Plastic Holders | Control Board |
Figure 1 | (Kit Number H1094) |
IR Cables
Figure 2
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. | 1 |
