WARNING: ALWAYS DISCONNECT POWER AND ALLOW THE ELECTRIC FIREPLACE TO COOL BEFORE PERFORMING ANY CLEANING, MAINTENANCE OR RELOCATION OF THIS ELECTRIC FIREPLACE. TURN CONTROLS TO OFF AND REMOVE PLUG FROM OUTLET OR TURN OFF CIRCUIT BREAKER TO ELECTRIC FIREPLACE.

BACK GLASS

1.The glass is cleaned in the factory during assembly. During shipment, installation , han- dling, etc.. the glass surface may collect dust particles. These can be removed by buffing lightly with a clean dry cloth. To access the back glass, refer to Figure 6 and the removal process in the next section.

2.To remove fingerprints or other marks, the glass can be cleaned with a damp cloth using a good quality household glass cleaner. The glass should be completely dried with a lint free cloth or paper towel.

3.In the event of glass breakage, vacuum all remaining glass pieces with a shop vac. DO NOT VACUUM WHILE PIECES ARE HOT! Re- move glass only with replacement parts spe- cifically for this heater. Never substitute ma- terial. Only fully tempered safety glass may be used on this heater.

BULB REPLACEMENT

WARNING: THE HALOGEN LIGHT BULBS IN YOUR UNIT CAN BECOME EXTREMELY HOT. ALLOW AT LEAST 10 MINUTES BETWEEN TURNING OFF THE HEATER AND REMOVING THE LIGHT BULBS TO AVOID ACCIDENTAL BURNS.

There are a total of 4 halogen light bulbs (type GX6.35 rated 120 volts, 35 watts) required for the operation of your unit:

*2 bulbs provide illumination for the ember bed beneath the log set.

*2 bulbs provide illumination for the flame generation assembly.

*2 bulbs for replacement are also supplied.

WARNING: DO NOT INSTALL REPLACEMENT BULBS THAT EXCEED SPECIFIC MAXIMUM WATTS.

Your fireplace unit must be opened in order to replace the light bulbs. To reduce the number of times you need to open the unit, replace all bulbs at the same time.

EMBER BED BULBS

1.Remove the door (see Figure 6 ) by grasping the door firmly at the bottom and supporting the top. Lift up and away.

Figure 6

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.

2.From the bottom of the ember bed (on the plastic), gently grasp and lift up log/ember bed until front edge clears the grate tines. Angle the ember bed (one end higher than the other) to clear it from the front of the unit (do not pull up on logs) (see Figure 7 ).

Figure 7

3.Release spring clip over one bulb (see Figure 8 ).

4.Hold socket and pull out the old bulb.

Spring Clip

Figure 8

5.Hold socket and push in new bulb (DO NOT exceed wattage).

6.Replace spring clip.

7.Replace steps 4 through 6 for second bulb.

8.Gently push log/ember bed down into place.

9.Reinstall the door. Catch all four tabs in the slots located at the four corners of the unit inside of the outer frame. Ensure the slots on the tabs engage the face frame as the door drops into place downwards.

7