Lenovo 6438, 6437 Completing the installation, ServeRAID controller, Hard disc drive backplane

a.Disconnect the existing SAS/SATA controller signal cable from the hard disk drive backplane and from the controller; then, remove the cable from the server.

b.Route the ServeRAID-MR10i signal cable as shown in the following illustration and connect it to the hard disk drive backplane.

1	ServeRAID controller	3	J9
2	Hard disc drive backplane	4	J8

If you have other devices to install, do so now. Otherwise, go to “Completing the installation.”

Completing the installation

To complete the installation, complete the following steps:

1.Install the cover. See “Installing the cover” on page 23 for more information.

2.Install the server in the rack cabinet. See the Rack Installation Instructions that come with the server for detailed information about how to install the server in a rack cabinet.

Attention:

v Install the server only in a rack cabinet that has perforated doors.

vDo not leave open space above or below an installed server in your rack cabinet. To help prevent damage to server components, always install a filler panel to cover the open space and to help ensure proper air circulation. See the documentation that comes with the rack cabinet for more information.

3.Connect the cables and power cords. See “Connecting the cables” on page 23 for more information.

4.Update the server configuration. See “Updating the server configuration” on page 24 for more information.

22ThinkServer RS110 Types 6435, 6436, 6437, and 6438: Installation Guide