Replacing the diskette drive
1. Remove the left-side and right-side covers. See “Removing the covers” on page
84.
2. Disconnect the signal and power cables from the rear of the hard disk drive.

Note: You will probably have to disconnect cables that are connected to the

system board and other drives to allow the diskette drive to be removed
from inside the chassis.
3. Remove the two screws that secure the drive on each side.
4. Slide the drive toward the rear of the chassis until it can be removed.
5. Slide the new drive into the bay until the screws holes on each side are aligned
and install two screws in each side of the drive.
6. Reconnect all signal and power cables that were disconnected. See “Identifying
parts on the system board” on page 87.

7. Go to “Completing the FRU replacement” on page 112.

Chapter 8. Replacing FRUs (Types 7387, 7388, 7389, 7393, 7394, and 7395) 109