Replacing the power switch/ LED assembly
1. Remove cover. See “Removing the cover” on page 114.
2. Remove the drive bay assembly. See “Removing and replacing the drive bay
assembly” on page 118.
3. Remove the hard disk drive. See “Replacing the hard disk drive” on page 140.
4. Disconnect the power switch/LED assembly cable from the system board. See
“Identifying parts on the system board” on page 116.
5. Remove the screw that secures the power switch/LED assembly to the chassis.
6. Note the power switch/LED assembly cable routing and remove the assembly
from the chassis.
7. Route the cable for the new power switch/LED assembly through the hole in
the chassis and to the system board.
8. Install the power switch/LED assembly into the chassis and secure the
assembly with the screw.
9. Connect the power switch/LED cable to the system board.
10. Reinstall the hard disk drive. See “Replacing the hard disk drive” on page
140.
11. Reinstall the drive bay assembly. See “Removing and replacing the drive bay
assembly” on page 118.
12. Go to “Completing the FRU replacement” on page 144.
Chapter 9. Replacing FRUs (Types 7390, 7391, 7392, 7396, 7397, and 7398) 143