Diagnostic Error Code FRU/Action
000-196-XXX
BIOS test halt, error threshold exceeded
1. Press F3 to review the log file
2. Re-start the test to reset the log file
000-197-XXX
BIOS test warning
1. Make sure the component that is called
out is connected and/or enabled. See
Chapter 6, “Using the Setup Utility,” on
page 51
2. Re-run test
3. Replace the component that is called out
in warning statement
4. Replace the component under test
000-198-XXX
BIOS test aborted
1. Make sure the component that is called
out is connected and/or enabled. See
Chapter 6, “Using the Setup Utility,” on
page 51
2. Flash the system and retest. See “Flash
update procedures” on page 209
3. Go to “Undetermined problems” on page
81
000-199-XXX
BIOS test failed, cause unknown
1. Go to “Undetermined problems” on page
81
2. Flash the system and re-test
3. Replace component under function test
000-250-XXX
BIOS APM failure
1. Flash the system. See “Flash update
procedures” on page 209
2. System board
000-270-XXX
BIOS ACPI failure
1. Flash the system. See “Flash update
procedures” on page 209
2. System board
001-000-XXX
System Test Passed
No action
001-00X-XXX
System Error
System board
001-01X-XXX
System Error
System board
001-024-XXX
System Addressing test failure
System board
001-025-XXX
System Checksum Value error
1. Flash the system. See “Flash update
procedures” on page 209
2. System board
001-026-XXX
System FLASH data error
1. Flash the system. See “Flash update
procedures” on page 209
2. System board
001-027-XXX
System Configuration/Setup error
1. Run Setup
2. Flash the system. See “Flash update
procedures” on page 209
3. System board
Chapter 7. Symptom-to-FRU Index 57