Lenovo 8288, 8342, 8329, 8297, 8380, 8326 manual Connecting drives, Connecting the first optical drive

Models: 8342 8326 8329 8380 8297 8288

1 64
Download 64 pages 1.39 Kb
Page 36
Image 36

Connecting drives

The steps to connect a drive are different depending on the type of drive. Use one of the following procedures for your drive connection.

Connecting the first optical drive

1.The drive requires two cables; a power cable that connects to the power supply and a signal cable that connects to the system board.

2.Locate the three-connector signal cable that comes with your computer or with the new drive.

3.Locate the IDE connector on the system board. See “Identifying parts on the system board” on page 12.

4.Connect one end of the signal cable to the drive and the other to the IDE connector on the system board. To reduce electronic noise, use the connectors at the end of the cable only.

5.Locate the extra four-wire power connector labelled P4 and connect it to the drive.

Connecting an additional optical drive, or parallel ATA hard disk drive

1.Locate the extra connector on the three-connector signal cable that is attached to the IDE connector on the system board. See “Identifying parts on the system board” on page 12.

2.Connect the extra connector on the signal cable to the new drive.

3.Locate the extra four-wire power connector and connect it to the drive.

20User Guide

Page 36
Image 36
Lenovo 8288, 8342, 8329, 8297, 8380, 8326 manual Connecting drives, Connecting the first optical drive