2.Remove the front bezel by releasing the three plastic tabs on the left side and pivoting the bezel outward. Carefully set the bezel to the side without disconnecting the power switch and LED assembly cable.
Note: Notice the spare retainer bracket 1 attached to the side of the upper drive cage.
Figure 12. Locating the spare retainer bracket
3.Remove the metal static shield from the drive bay using your fingers to pull it outward.
4.If you are installing a drive with accessible media, such as an optical drive, remove the plastic panel in the bezel for bay 2 by squeezing the plastic tabs that secure the panel on the inside of the bezel.
5.If you are installing any type of drive other than a serial ATA drive, make sure the drive that you are installing is set correctly as either a master or a slave device.
Note: A serial ATA drive does not need to be set as either a master or a slave device.
If you are installing a parallel ATA drive, set it as a master device. Refer to the documentation that comes with your drive for master/slave jumper information.
6.Remove the retainer bracket from the upper driver cage by sliding it downward.
