Lenovo 9625, 9705, 9421, 9353, 9485, 9623, 7061 Replacing the mouse, Completing the parts replacement

Replacing the mouse

Attention

Do not open your computer or attempt any repair before reading and understanding the “Important safety information” in the ThinkCentre Safety and Warranty Guide that came with your computer. To obtain a copy of the ThinkCentre Safety and Warranty Guide, go to: http://www.lenovo.com/support

This section provides instructions on how to replace the mouse.

To replace the mouse:

1.Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect all power cords from electrical outlets and disconnect all cables that are connected to the computer.

2.Locate the connector for the mouse.

Note: Your mouse might be connected to a PS/2 mouse connector 1 or a USB connector 2. Depending on where your mouse is connected, see “Locating connectors on the rear of your computer” on page 9 or “Locating connectors on the front of your computer” on page 8.

Figure 36. Mouse connectors

3.Disconnect the failing mouse cable from the computer.

4.Connect a new mouse cable to the appropriate connector on the computer.

5.Go to “Completing the parts replacement.”

Completing the parts replacement

After completing all parts replacements, you need to reinstall the computer cover and reconnect cables, including telephone lines and power cords. Depending on the parts replaced, you might need to confirm the updated information in the Setup Utility program. Refer to Chapter 4, “Using the Setup Utility,” on page 59.

To reinstall the computer cover and reconnect cables to your computer:

1.Ensure that all components have been reassembled correctly and no tools or loose screws are left inside your computer. See “Locating components” on page 11 for the location of various components.

Chapter 2. Installing or replacing hardware 45