![](/images/new-backgrounds/1176153/176153213x1.webp)
1 Operator information panel connector 2 Operator information panel cable
4.Install the cover (see “Removing and replacing the cover” on page 43).
5.Slide the server into the rack.
6.Reconnect the power cords and any cables that were removed.
7.Turn on the peripheral devices and the server.
Removing and installing the system board
To remove and install the system board, complete the steps in this section.
Removing the system board
To remove the system board, complete the following steps.
Notes:
1.When you replace the system board, make sure that you remove IMM Premium and place it on the new system board. For information about the location of the key, see
2.When you replace the system board, you must either update the server with the latest firmware or restore the
1.Read the safety information in “Safety” on page vii and “Installation guidelines” on page 39.
2.Turn off the server and peripheral devices and disconnect all power cords; then, remove the cover (see “Removing and replacing the cover” on page 43).
Note: When you replace the system board, you must either update the server with the latest firmware or restore the
Chapter 5. Installing optional devices and replacing customer replaceable units 91