Lenoxx Electronics PH-543 operating instructions Setting up the telephone

GETTING STARTED

Step 3: Setting up the telephone

SETTING UP LCD CONTRAST, LANGUAGE, AREA CODE, TIME & DATE, AND TONE OR PULSE MODE

You may need to set up the LCD contrast, language, area code, time and date, and tone or pulse mode for your telephone when you install the batteries for the first time or when you move to an area that has a different area code. This is necessary because the phone must distinguish local or long distance calls to properly dial calls from the Caller ID list.

NOTE: During setup, if you do not press the DELETE button within 20 seconds, the display will get back to normal display mode.

Press and hold the DELETE button, then press
the DOWN button, the LCD CONTRAST (5-
grey level) will show on the display. Use the
UP or DOWN button to select the suitable grey-
level and press the DELETE button to accept.
Then SET LANGUAGE will show in the
display, the default language “E” (English) will
flash. Press UP or DOWN to choose your	“E” = English;
desired language (flashing). Press the DELETE
	“F” = French;
button to confirm and accept.	“S” = Spanish

Your phone now will ask you to set your
Area Code:		AREA CODE
		E X A M P L E :
		718	Press UP/DOWN & DELETE
While the first digit is flashing, you should:
1.	Press the UP or DOWN button till the
	first digit of your area code is displayed
	(flashing).		Press UP/DOWN & DELETE
2.	Press the DELETE button to accept
	and go to the next digit.
3.	Repeat above steps 1 and 2 to set the
	2nd and 3rd digits of your area code.		Press UP/DOWN & DELETE

Afterwards, your phone will now go to the Time and Date mode, press the UP or DOWN button to get the correct number and press the DELETE button to accept. Then the phone will ask you to select Tone or Pulse mode, press the UP or DOWN button to select your desired dialing mode(“>” flashes before it) and press the DELETE button to confirm until the normal display shows.

7IB-PH543(168F)-WM-E-051203