Leupold PS536GS manual III. Assembly, Top Panel and Base Pad Assembly

III. ASSEMBLY

A.Top Panel and Base Pad Assembly

SECTION 2 - INSTALLATION

Figure 2-3 - Leg extension and casters installation

1. Install the four leg extensions onto the base pad using the
	3/8"-16x1" screws, 3/8" flat washers, and 3/8" lockwashers
	supplied in the Base Pad Kit. See Figure 2-3. Check that
	the finished sides of each leg extension face OUTWARDS.
	For domestic and standard export ovens:
	One rear leg should be attached using three 3/8"-16 x 1"
	screws and the 3/4" eyebolt, as shown in Figure 2-3. This
	eyebolt acts as the anchor point for the restraint cable
	assembly (see Part C, Restraint Cable Installation).
2. If your oven is equipped with the lower shelf, position it in
	place as shown in Figure 2-3. Check that the lip on the shelf
	faces DOWN. Seal joint between leg and shelf with NSF
	listed silicone.
3. For domestic and standard export ovens:
	Install one caster onto each leg extension, as shown in
	Figure 2-4. Use the 3/8"-16x1" screws, 3/8" flat washers,
	and 3/8" lockwashers supplied in the Installation Kit. The
	locking casters should be installed at the FRONT of the
	oven. The non-locking casters should be installed at the
	REAR of the oven.
	For CE export ovens:
	The Installation Kit includes four casters AND four 152mm
	adjustable legs. The casters are provided to allow the oven
	to be more easily moved to the installation location, and are
	NOT suitable for use as part of the oven installation. Refer
	to the notice at the beginning of this Section.
	After the oven is at the installation location, install one
	152mm adjustable leg into the center hole on the bottom
	of each leg extension, as shown in Figure 2-4.
4.	Install the lower oven cavity onto the base pad. See Fig. 2-4.
5.	For single ovens ONLY, install the top panel using the

Finished sides of

leg extension face corner of base pad

CE ovens do not use the eyebolt.

Lower

shelf

CE-approved

ovens:

152mm adjustable leg MUST be used for installation

3/8" flat

washer

3/8" lock

washer

3/8"-16 x 1" hex screw

3/4" eyebolt (inside corner of one rear leg extension only)

Domestic and

standard export

ovens:

Locking casters -

FRONT of oven

Non-locking casters -

REAR of oven

3/8" flat

washer

3/8" lock

washer

3/8"-16 x 1"

hex screw

ENGLISH

screws included in the base pad kit, as shown in Figure 2-

5. Then, skip ahead to Part C, Restraint Cable Installation.

For double or triple ovens, continue on to Part B, Stacking. Note that the top panel should NOT be installed for double

Figure 2-5 - Top panel installation

NOTE: DO NOT install top panel onto double or triple ovens until AFTER stacking the oven cavities. See Part B, Stacking.

#10 x 2"

and triple ovens until after stacking the oven cavities.

screws

Top

Figure 2-4 - Base pad installation

Bottom oven

cavity

Assembled

base pad

panel

9