52
ENG
ENGLISH
CUSTOMIZING SETTINGS
Picture ID
Picture ID is used to change the settings of a
specic display using a single IR receiver for multi-
vision. Communication is possible between a set
with an IR receiver and other sets using audio
cables. Each set is identied by a set ID. If you
assign the Picture ID using the remote control, only
displays with the same Picture ID and Set ID can
be controlled remotely.
1 Press the red ON button on the remote control
to assign the Picture ID.
2 If you press the left/right buttons or press the
ON button repeatedly, the Picture ID cycles
through OFF and 0 to 4. Assign the ID you
want.
yIf you assign the Set ID to each set with
multi-vision, and then assign the Picture ID
using the red button on the remote control,
the key command is displayed for the set
with the same Set ID and Picture ID. A set
with different Set IDs and Picture IDs cannot
be controlled by IR signals.
yFor more information on how to assign the
Set ID, see "Set ID" on page 47.
yPlease refer to the Installation Manual for
more information on Total Set ID assignment.
P
A
G
E
P
EEG
AG
A
A
A
E
G
P
A
EA
E
P
A
E
G
E
E
A E
E
PE
P
A
G
E
P
EEG
AG
A
A
A
E
G
P
A
EA
E
P
A
E
G
E
E
A E
E
PE
yFor example, if the Picture ID is assigned to
2, the upper right display (Set ID: 2) can be
controlled by IR signals.
yFor each set, you can change the settings
for the PICTURE, AUDIO, TIME, NETWORK
and MY MEDIA menus or the hot keys on
the remote control.
y If you press the green OFF button for Picture
IDs, the Picture IDs for all sets are turned off.
If you then press any button on the remote
control, all sets will start working again.
yPicture ID will be disabled while using the
MY MEDIA menu.
NOTE
Picture ID
Close
◀ Off ▶
2X2 Multi-Vision (Total Set ID: 4)
Set IDs are assigned as shown in the picture.
AUDIO
(RGB/DVI)
REMOTE
CONTROL IN
RC OUT
RC IN
RC OUT
RC IN
RC OUT
RC IN
IR Receiver
Audio cable
Picture ID
Close
Off