LG Electronics 22LT560C, 26LT560C, 32LT560C, 32LT560E, 37LT560C, 37LT560E, 42LT560C, 42LT560E, 47LT560E INSTALLATION PROCEDURE, ASSEMBLING AND PREPARING

ENG

ENGLISH

ASSEMBLING AND PREPARING

INSTALLATION PROCEDURE

1 Open the package and make sure all the accessories are included.

2 Attach the stand to the TV set.

3 Connect an external device to the TV set.

ASSEMBLING AND PREPARING

Unpacking

Check your product box for the following items. If there are any missing accessories, contact the local

dealer where you purchased your product. The illustrations in this manual may differ from the actual

product and item.

CAUTION

yy To ensure safety and product life span, do not use any unapproved items.

yy Any damages or injuries sustained due to use of unapproved items are not covered by the warranty.

yy In the case of some models, the thin film on the screen is a part of TV and should not be removed.

NOTE

yy The items supplied with your product will vary depending on the model.

yy Product specifications and/or manual contents subject to change without prior notice due to upgrade

of product functions.

Contents

Main QUICK REFERENCE GUIDE LED LCD TV Please read this manual carefully before operating your set and retain it for future reference. LICENSES OPEN SOURCE SOFTWARE NOTICE IMPORTANT SAFETY INSTRUCTIONS Page Short-circuit Breaker Power Supply Page TABLE OF CONTENTS INSTALLATION PROCEDURE 1 2 3 ASSEMBLING AND PREPARING Unpacking Page Optional Extras (For LT560E series) Parts and buttons Setting up the TV Attaching the stand CAUTION Mounting on a table 1 2 CAUTION Mounting on a wall 1 2 3 Tidying cables 1 2 1 REMOTE CONTROL CHVOL 1 2 3 4 5 6 7 8 0 9 CHVOL 1 2 3 4 5 6 7 8 0 9 GENERAL TROUBLESHOOTING Display Panel Picture Picture Reception CAUTION FOR USING EzSIGN 2.0 For 32/37/42/47LT560E SPECIFICATIONS Product specifications may be changed without prior notice due to upgrade of product functions. RGB(PC), HDMI (PC) supported mode For 37/42LT560C, 37/42/47LT560E HDMI (DTV) supported mode IR CODES (Depending on model) EXTERNAL CONTROL DEVICE SETUP RS-232C Setup Type of connector; D-Sub 9-Pin Male RS-232C configurations 1 2 3 4 Communication Parameters yy Baud rate: 9600 bps (UART) yy Data length: 8 bits yy Parity : None yy Stop bit: 1 bit yy Communication code: ASCII code yy Use a crossed (reverse) cable. Command reference list Transmission / Receiving protocol Page Page Page * Table List (Channel Tuning) Page Page Page CHILD SAFETY: It Makes A Difference How and Where You Use Your Flat Panel Display THE ISSUE THIS MANUFACURER CARES! TUNE INTO SAFETY

LG Electronics INSTALLATION PROCEDURE, ASSEMBLING AND PREPARING

Models: 22LT560C 26LT560C 32LT560C 32LT560E 37LT560C 37LT560E 42LT560C 42LT560E 47LT560E

Unpacking