LG Electronics 37LD650H Cloning CONNECTIONS/TEACHING Setup, Disconnect TV Power for 15 Seconds

CLONING CONNECTIONS/TEACHING SETUP

Teaching the Master Setup to Another TV

Connections for the LT2002 to Teach another TV the Master Setup

Antenna
or CATV			Ferrite Core	TV MPI Jack and
				Connect cable to
			(TDK, ZCAT	follow on screen	Status
				instructions	Indicator
			2035-0930)	MPI
					Reset
					Color
				• green	battery ok
				• red	battery low
				Blink pattern
				• slow	power on
					no communications
				• heartbeat power on
					communications ok
THE CLONE HAS CONTROL OF THE TV
THE CLONE IS VERSION			XX
THE TV IS VERSION			XX
THE SW IS REVISION			XX
CLONE CLOCK =		XX:XX
TV CLOCK	=	XX:XX
-PRESS ANY KEY TO CONTINUE.				QuickSet II Programmer
-DISCONNECT CLONE WHEN DONE.				LT2002

Target TV Clone Programmer

!NOTE

G If an analog channel is not available, tune TV to an Aux source like AV-1 for cloning purposes.

Teach Master TV’s Setup to the target TV

After learning is complete, remove the M.P.I. cable from the mas- ter TV and connect it to the target TV that you want to copy the master TV’s setup into. With “THE CLONE HAS CONTROL OF TV” message displayed, press 2 or use either Channel key to go to the “TEACH TO TV” option, press ON/OFF, POWER, or ENTER. Select the LT2002 memory that the new setup is in. Press On/Off to transfer the new setup and other information to the new TV. Teaching usually takes 2-3 minutes.

After the “TEACHING COMPLETE” message is displayed, press any key to return to the Clone menu, then press ON/OFF, POWER, or ENTER. If finished, detach M.P.I. cable from the target, newly-cloned TV.

Disconnect TV Power for 15 Seconds

Unplug the AC power cord of the newly-cloned TV from the power outlet for about 15 seconds to activate the newly-copied setup.

CLONE SELECTION MENU

(1)LEARN FROM TV

(2)TEACH TO TV

(3)SET CLONE CLOCK FROM TV

(4)SET TV CLOCK FROM CLONE

(5)DISPLAY TV SETUP

(6)DISPLAY CLONE SETUP

-TO CHANGE MENU ITEMS, PRESS CHANNEL KEYS OR DIGITS.

-TO EXECUTE ITEM, PRESS ON/OFF, POWER, OR ENTER

This menu should appear after any key is pressed on the Installer remote.

TEACHING IN PROGRESS,

PLEASE WAIT

This display will appear during Teaching function.

TEACHING COMPLETE

This display will appear after Teaching is complete.

COMMERCIAL MODE SETUP

105