LG Electronics AMNH123DEA0 (LMN120HE) service manual Gas Charging, 2-way, 3-way Valve, Procedure

Models: AMNC093APM0(LMAN090CNS) AMNH123DEA0 (LMN120HE) A2UC243FA0 (LMU240CE) AMNH123APM0(LMAN120HNS) A2UH243FA0(LMU240HE) AMNH093APM0(LMAN090HNS) AMNC123DEA0 (LMN120CE)

1 86
Download 86 pages 417 b
Page 79
Image 79
(3) Gas Charging

2-way, 3-way Valve

(3) Gas Charging

(After Evacuation)

Indoor unit

Liquid side

 

Open

Outdoor unit

2-Way

valve

Gas side

Open

3-Way

valve

Indoor unit

Liquid side

 

Open

2-Way

valve

Gas side

Open

3-Way

valve

Charging

manifold gauge

cylinder

 

Low-handle

Check valve (OPEN)Hi- handle (OPEN)

• Procedure

1.Connect the gauge to the charging cylinder.

-Connect the charge hose which you disconnect- ed from the vacuum pump to the valve at the bottom of the cylinder.

-If you are using a gas cylinder, also use a scale and reverse the cylinder so that the system can be charged with liquid.

2.Purge the air from the charge hose.

-Open the valve at the bottom of the cylinder and press the check valve on the charge set to purge the air. (Be careful of the liquid refrigerant). The procedure is the same if using a gas cylinder.

3.Open the low handle on the gauge and charge the system with liquid refrigerant.

-If the system can not be charged with the speci- fied amount of refrigerant, it can be charged with a little at a time (approximately 150g each time) while operating the air conditioner in the cooling cycle; however, one time is not suffi- cient, wait approximately 1 minute and then repeat the procedure(pumping down-pin).

4.Immediately disconnect the charge hose from the gas side valve's service port.

This is different from previous procedures. Because you are charging with liquid refrigerant from the gas side, absolutely do not attempt to charge with larger amounts of liquid refrigerant while operating the air conditioner.

- Stopping partway will allow the gas to be dis- charged.

-If the system has been charged with liquid refrigerant while operating the air conditioner turn off the air conditioner before disconnecting the hose.

5.Mount the valve stem nuts and the service port nut.

-Use torque wrench to tighten the service port nut to a torque of 1.8 kg.m.(4.2kg.m/5.5kg.m.)

-Be sure to check for gas leakage.

Service Manual 79

Page 79
Image 79
LG Electronics AMNH123DEA0 (LMN120HE), A2UC243FA0 (LMU240CE) Gas Charging, 2-way, 3-way Valve, Procedure, After Evacuation